Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 95)

NCK alarms

06/2009 Overview of alarms

2-95

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

14045 [Channel %1: ] Block %2 error in tangential circle programming

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The alarm may have the following causes:

The tangent direction is not defined for tangent circle, e.g. because no other travel block has been

programmed before the current block. No circle can be formed from start and end point as well as tan-

gent direction because - seen from the start point - the end point is located in the opposite direction to

that indicated by the tangent.

It is not possible to form a tangent circle since the tangent is located perpendicular to the active plane.

In the special case in which the tangent circle changes to a straight line, several complete circular rev-

olutions were programmed with TURN.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14048 [Channel %1: ] Block %2 wrong number of revolutions in circle

programming

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In the circle programming, a negative number of full revolutions has been specified.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14050 [Channel %1: ] Block %2 nesting depth for arithmetic operations

exceeded

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: For calculating arithmetic expressions in NC blocks, an operand stack with a fixed set size is used.

With very complex expressions, this stack can overflow. This may also occur with extensive expres-

sions in synchronized actions.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Divide up complex arithmetic expressions into several simpler arithmetic blocks.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14051 [Channel %1: ] Block %2 arithmetic error in part program

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: - In calculating an arithmetic expression, an overflow has occurred (e.g. division by zero)

- In a data type, the representable value range has been exceeded

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Analyze the program and correct the defective point in the program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 95

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl