Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 144)

Overview of alarms 06/2009

NCK alarms

2-144

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

$MA_... [X]= ... ; but geometry axis X cannot be imaged on a machine axis because of a transforma-

tion!

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Deselect transformation before writing into the axial data (keyword: TRAFOOF) or use the machine

axis names as axis index.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17050 [Channel %1: ] Block %2 illegal value

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A value has been programmed that exceeds the value range or the limit value of a variable or a

machine data.

Example: - in a string variable (e.g. GUD or LUD) a string shall be written that exceeds the string length

agreed upon in the variable definition.

- if an invalid value is to be written in a tool or magazine management variable ( e.g. invalid cutting

edge number in $TC_DPCE[x,y] or invalid magazine location number in $TC_MDP2[x,y]).

- an invalid value is to be written in $P_USEKT or $A_DPB_OUT[x,y].

- an invalid value is to be written in a machine data (e.g. MD10010

$MN_ASSIGN_CHAN_TO_MODE_GROUP[0] = 0).

- on accessing an individual frame element, a frame component other than TRANS, ROT, SCALE

or MIRROR was addressed or the function CSCALE has been given a negative scale factor.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Address frame components only with the keywords provided; program the scale factor between the

limits of 0.000 01 to 999.999 99.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

17060 [Channel %1: ] Block %2 requested data area too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The maximum memory space of 8 KB available for a symbol has been exceeded.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Reduce array dimensions.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17070 [Channel %1: ] Block %2 data is write-protected

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An attempt was made to write into a write-protected variable (e.g. a system variable). Safety Inte-

grated: Safety system variables can only be written into via the safety SPL program.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department. Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17080 [Channel %1: ] Block %2 %3 value below lower limit

Parameters: %1 = Channel number

%2 = Block number, label

%3 = MD

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 144

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl