Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 145)

NCK alarms

06/2009 Overview of alarms

2-145

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Definitions: An attempt was made to write into a machine data with a value smaller than the defined lower limit.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department. Determine the input limits of the machine

data and assign a value within these limits.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17090 [Channel %1: ] Block %2 %3 value exceeds upper limit

Parameters: %1 = Channel number

%2 = Block number, label

%3 = MD

Definitions: An attempt was made to write into a machine data with a value greater than the defined upper limit.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department. Determine the input limits of the machine

data and assign a value within these limits.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17095 [Channel %1: ] Block %2 invalid value

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An attempt was made to write an invalid value, e.g. zero, into a machine data.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Correct the value assignment, e.g. a value within the value range not equal to zero.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17100 [Channel %1: ] Block %2 digital input/comparator no. %3 not activated

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Input number

Definitions: Either an attempt was made to read a digital input n via the system variable $A_IN[n] and this input

has not been activated via NCK MD10350 $MN_FASTIO_DIG_NUM_INPUTS; or to read a compar-

ator input via system variable $A_INCO[n] and this input belongs to a comparator which has not been

activated.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department. Modify part program or machine data

accordingly.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17110 [Channel %1: ] Block %2 digital output no. %3 not activated

Parameters: %1 = Channel number

%2 = Block number, label

%3 = No. of output

Definitions: An attempt was made to read or set a digital NCK output (connector X 121) via the system variable

$A_OUT [n] with the index [n] greater than the specified upper limit in MD10360

$MN_FASTIO_DIG_NUM_OUTPUTS.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 145

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl