Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 287)

PROFIBUS alarms

06/2009 Overview of alarms

2-287

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

380076 PROFIBUS/PROFINET: No DO1 message frame: Bus %2 slave/device %1

Parameters: %1 = Slave/device address

%2 = Number of the affected bus

Definitions: Note for the system startup engineer: A PROFIBUS slave/PROFINET device used as an NCK drive

does not have a valid DO1 message frame assignment (see MD13120

$MN_CONTROL_UNIT_LOGIC_ADDRESS with the STEP 7 configuration).

This alarm is indicating, among other things, that the alarm time-of-day synchronization is not working

between the controller and this slave/device.

Reaction: Alarm display.

Remedy: Enter a valid value in MD13120 $MN_CONTROL_UNIT_LOGIC_ADDRESS.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

380500 PROFIBUS/PROFINET: Fault on drive %1, code %2, value %3, time %4

Parameters: %1 = Axis

%2 = Fault code of drive (P947(/945)/P824)

%3 = Fault value of drive ((P949/P826)

%4 = Fault time of drive (P948/P825)

Definitions: Contents of fault memory of assigned drive.

Reaction: Alarm display.

Remedy: See drive documentation for fault codes/fault values.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

380501 PROFIBUS/PROFINET: Fault on bus, slave/device, DO ID %1, code %2,

value %3, time %4

Parameters: %1 = 8 bit bus number, 8 bit slave/device number, 16 bit DO ID

%2 = Fault code of drive (P947)

%3 = Fault value of the drive (P949)

%4 = Fault time of the drive (P948)

Definitions: Contents of the fault memory of the assigned slave/device.

Reaction: Alarm display.

Remedy: See drive documentation for fault codes/fault values.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

380502 PROFIBUS/PROFINET: Bus %1, slave/device %2 configuration changed

Parameters: %1 = Bus number

%2 = Slave/device address

Definitions: The bus configuration has changed.

Causes:

- Initial start-up

- New slave/device recognized on the bus

Reaction: Interface signals are set.

Alarm display.

Remedy: In order to operate the bus with the new configuration, an additional restart will be required.

Program Con-

tinuation:

Switch control OFF - ON.

380503 PROFIBUS/PROFINET: Bus %1 configuration changed

Parameters: %1 = Bus number

Definitions: A new SDB with a modified configuration has been provided.

The new settings will be activated only at the next bus power up.

Reaction: Interface signals are set.

Alarm display.

Remedy: In order to operate the bus with the new configuration, an additional restart will be required.

Program Con-

tinuation:

Switch control OFF - ON.

1 2 ... 282 283 284 285 286 287 288 289 290 291 292 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 287

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl