Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 201)

Cycle alarms

06/2009 Overview of alarms

2-201

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61112 [Channel %1: ] Block %2: Tool radius negative

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The radius of the active tool is negative. This is illegal. Alarm triggered by following cycles: CYCLE72,

CYCLE76, CYCLE77, CYCLE90.

Remedy: Change the tool radius.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61113 [Channel %1: ] Block %2: Parameter _CRAD too large for corner radius

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The parameter for the corner radius _CRAD has been specified too large. Alarm triggered by following

cycle: POCKET3.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Parameter must be reduced.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61114 [Channel %1: ] Block %2: Machining direction G41/G42 incorrectly

defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The machining direction of the cutter radius compensation G41/G42 has been incorrectly selected.

Alarm triggered by following cycle: CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Change machining direction.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61115 [Channel %1: ] Block %2: Approach or retract mode(straight / circle /

plane / space) incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The approach or retract mode to/from the contour has been incorrectly defined. Alarm triggered by

following cycle: CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check parameter _AS1 or _AS2.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61116 [Channel %1: ] Block %2: Approach or retract path = 0

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The approach or retract path has been specified with zero. Alarm triggered by following cycle:

CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 201

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl