Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 154)

Overview of alarms 06/2009

NCK alarms

2-154

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Please inform the authorized personnel/service department. Modify program or set MD18600

$MN_MM_FRAME_FINE_TRANS to 1.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

18310 [Channel %1: ] Block %2 frame: illegal rotation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Rotations are not possible with NCU global frames.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

18311 [Channel %1: ] Block %2 frame: illegal instruction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An attempt was made to read or write a frame which does not exist.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

18313 [Channel %1: ] Block %2 frame: illegal switchover of geometry axes

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: It is not allowed to change the geometry axis assignment because the current frame contains rota-

tions.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Change NC program or set other mode with MD10602 $MN_FRAME_GEOAX_CHANGE_MODE.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

18314 [Channel %1: ] Block %2 frame: type conflict

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: It is not possible to chain global frames and channel-specific frames. The alarm occurs if a global

frame is programmed with a channel axis name and no machine axis on this NCU is assigned to the

channel axis. Channel-specific frames cannot be programmed with machine axis names if there is no

corresponding channel axis on this NCU.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 154

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl