Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 220)

Overview of alarms 06/2009

Cycle alarms

2-220

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61240 [Channel %1: ] Block %2: Wrong feed type

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The feed type is not possible for this machining.

Alarm triggered by following cycles: F_DRM_DR, F_DRM_PE, F_DRM_RE, F_DRM_SI, F_GROOV,

F_MIM_TR, F_ROUGH, F_SP_EF, F_UCUT_T

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check feed type.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61241 [Channel %1: ] Block %2: Retraction plane not defined for this machining

direction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No retraction plane has been defined for the selected machining direction.

Alarm triggered by following cycles: F_SP_RP, F_SP_RPT.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Define the missing retraction plane.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61242 [Channel %1: ] Block %2: Wrong machine direction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The machining direction has been specified incorrectly.

Alarm triggered by following cycles: F_DR, F_DR_PEC, F_DR_REA, F_DR_SIN, F_DR_TAP,

F_DRILL, F_DRILLC, F_DRILLD, F_DRM_DR, F_DRM_PE, F_DRM_RE, F_DRM_SI, F_DRM_TA,

F_MI_CON, F_MI_EDG, F_MI_TR, F_MI_TXT, F_MIM_TR, F_PI_CIR, F_PI_REC, F_PO_CIR,

F_PO_REC, F_SL_CIR, F_SL_LON, F_TAP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check the programmed machining direction.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61243 [Channel %1: ] Block %2: Correct tool change point, tool tip in

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The tool change point must be situated so far outside the retraction area that no tool protrudes into

the retraction area on turret swivelling.

Alarm triggered by following cycle: F_SP_RP

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Specify another tool change point.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 220

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl