Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 212)

Overview of alarms 06/2009

Cycle alarms

2-212

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61192 [Channel %1: ] Block %2: second 5 axis transformation not set up

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The alarm is triggerd by the following cycles: CYCLE832.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61193 [Channel %1: ] Block %2: compressor option not set up

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The alarm is triggerd by the following cycles: CYCLE832.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61194 [Channel %1: ] Block %2: spline interpolation option not set up

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The alarm is triggerd by the following cycles: CYCLE832.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61196 [Channel %1: ] Block %2: no swiveling in JOG --> 5 axis transformation

and TCARR simultaneously activated

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: 5-axis transformation and TOOLCARRIER activated at the same time.

Alarm triggered by following cycles: CYCLE800.

Remedy: 5-axis transformation and TOOLCARRIER activated at the same time.

61197 [Channel %1: ] Block %2: no swiveling in JOG --> active WO G%4 and

basic frames contain rotations

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE800.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 212

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl