Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 256)

Overview of alarms 06/2009

Cycle alarms

2-256

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61708 [Channel %1: ] Block %2: internal cycle error with READYPROG at HMI

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61709 [Channel %1: ] Block %2: Timeout in contour calculation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE950.

Remedy: --

61710 [Channel %1: ] Block %2: Stock removal program not available

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61711 [Channel %1: ] Block %2: Name of stock removal program missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61712 [Channel %1: ] Block %2: Tool parameter for machining direction not

defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61720 [Channel %1: ] Block %2: Incorrect parameter input.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE950.

Remedy: --

61721 [Channel %1: ] Block %2: Error contour direction cannot be determined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE950.

1 2 ... 251 252 253 254 255 256 257 258 259 260 261 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 256

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl