Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 222)

Overview of alarms 06/2009

Cycle alarms

2-222

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Increase infeed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61249 [Channel %1: ] Block %2: Number of edges too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The number of edges is too small.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase number of edges.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61250 [Channel %1: ] Block %2: Width across flats/edge length too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The width across flats/edge length is too small.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase key width/edge length.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61251 [Channel %1: ] Block %2: Width across flats/edge length too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The width across flats/edge length is too large.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Decrease key width/edge length.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61252 [Channel %1: ] Block %2: Chamfer/radius too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Chamfer/radius is too large.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Decrease chamfer/radius.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61253 [Channel %1: ] Block %2: No finishing allowance programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No finishing allowance has been entered.

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 222

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl