Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 249)

Cycle alarms

06/2009 Overview of alarms

2-249

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61526 [Channel %1: ] Block %2: Workpiece radius = 0

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE414

Remedy: Enter workpiece radius > 0

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61527 [Channel %1: ] Block %2: Grinding wheel radius >= workpiece radius

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE414

Remedy: Change grinding wheel radius or workpiece radius

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61529 [Channel %1: ] Block %2: Dimensional notation INCH programmed

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE410, CYCLE411, CYCLE412,

CYCLE413, CYCLE414, CYCLE415, CYCLE420

Remedy: Basic system MD $MN_SCALING_SYSTEM_IS_METRIC does not correspond to programmed G

command (G group 13).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61530 [Channel %1: ] Block %2: Default longitudinal position incorrect

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE420

Remedy: Check longitudinal position parameter

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61531 [Channel %1: ] Block %2: Longitudinal position not registered in Z

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE420

Remedy: Increase infeed path parameter

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61532 [Channel %1: ] Block %2: Value for _LAGE is incorrect

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE414

Remedy: Correct parameter content for _LAGE

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61533 [Channel %1: ] Block %2: No length L1 entered under D...

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE416, CYCLE420

Remedy: Enter length L1 in the tool offset D of the grinding wheel

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 244 245 246 247 248 249 250 251 252 253 254 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 249

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl