Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 223)

Cycle alarms

06/2009 Overview of alarms

2-223

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Alarm triggered by following cycles: E_PO_CIR, E_PO_REC, E_SL_CIR, E_SL_LON, F_PO_CIR,

F_PO_REC, F_SL_CIR, F_SL_LON.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Programm a finishing allowance.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61254 [Channel %1: ] Block %2: Error while traveling to fixed stop

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Error on travelling to fixed stop.

Alarm triggered by following cycle: F_SUB_SP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: specify another Z1 position for gripping the counterspindle.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61255 [Channel %1: ] Block %2: Error during cut-off: Tool broken?

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Cut-off could not be completed. A tool breakage might have occurred.

Alarm triggered by following cycles: F_PARTOF, F_SUB_SP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check the tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61256 [Channel %1: ] Block %2: Mirroring not allowed at program start.

Deselect work offset!

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Mirroring impermissible at program start.

Alarm triggered by following cycle: F_HEAD.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Deselect work offset.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61257 [Channel %1: ] Block %2: incomplete installation of counterspindle

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Start-up of the counterspindle is incomplete.

Alarm triggered by following cycle: F_SUB_SP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check display machine data 9803, 9851, 9852, 9853 and 9854 .

1 2 ... 218 219 220 221 222 223 224 225 226 227 228 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 223

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl