Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 125)

NCK alarms

06/2009 Overview of alarms

2-125

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

The alarm can occur together with a dwell or a spindle function.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department.

Check the part program to determine whether the programmed spindle number is correct and whether

the program is run in the correct channel.

Check MD35000 $MA_SPIND_ASSIGN_TO_MACHAX for all machine axes to see whether one of

them contains the programmed spindle number. This machine axis number must be entered in a chan-

nel axis of the machine data MD20070 $MC_AXCONF_MACHAX_USED.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16105 [Channel %1: ] Block %2 spindle %3 cannot be assigned

Parameters: %1 = Channel number

%2 = Block number, label

%3 = String

Definitions: Mistake in programming: The programmed spindle is not assigned a real spindle by the spindle num-

ber converter. The alarm can be issued after improper use of SD42800 $SC_SPIND_ASSIGN_TAB[].

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Correct setting data or modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

16111 [Channel %1: ] Block %2 spindle %3 No speed programmed

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Spindle

Definitions: Programming of a speed is expected.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program speed with S[spindle number]=..

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16200 [Channel %1: ] Block %2 spline and polynominal interpolation not

available

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The spline and polynomial interpolation are options that are not contained in the basic version of the

control.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Do not program spline and polynomial interpolation, or retrofit the necessary option.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16410 [Channel %1: ] Block %2 axis %3 is not a geometry axis

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: A geometry axis has been programmed that cannot be imaged on any machine axis in the current

transformation (possibly there is no transformation active at the moment).

Example:

Without transformation: Polar coordinate system with X, Z, and C axis

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 125

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl