Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 246)

Overview of alarms 06/2009

Cycle alarms

2-246

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: A tool offset value has to be programmed

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61504 [Channel %1: ] Block %2: _KNG incorrect for setup

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: setup function

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61505 [Channel %1: ] Block %2: retraction path < 1mm

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE420

Remedy: Increase retraction path

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61506 [Channel %1: ] Block %2: infeed path < 1mm

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE420

Remedy: Increase infeed path

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61507 [Channel %1: ] Block %2: safety clearance < 1mm

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: setup function

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61508 [Channel %1: ] Block %2: Incorrect default setting for shoulder position

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: setup function

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61509 [Channel %1: ] Block %2: Incorrect default setting for dresser position

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: setup function

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61510 [Channel %1: ] Block %2: Test run feed is active

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE410, CYCLE411, CYCLE413,

CYCLE415, CYCLE420

Remedy: Switch off test run feed

1 2 ... 241 242 243 244 245 246 247 248 249 250 251 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 246

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl