Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 92)

Overview of alarms 06/2009

NCK alarms

2-92

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Alarm display.

Remedy: Ensure that the subroutine (alarm parameter %3)

- is available in the parts program memory

- has been released and is not being edited

- is available in the search path if not being called via an absolute path name.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14012 [Channel %1: ] Block %2 maximum subroutine level exceeded

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The maximum nesting depth of 8 program levels has been exceeded.

Subroutines can be called from the main program, and these in turn may have a nesting depth of 7.

In interrupt routines the maximum number of levels is 4!

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify the machining program so that the nesting depth is reduced, e.g. using the editor copy a sub-

routine of the next nesting level into the calling program and remove the call for this subroutine. This

reduces the nesting depth by one program level.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14013 [Channel %1: ] Block %2 number of subroutine passes invalid

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In a subroutine call the programmed number of passes P is zero or negative.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program number of passes between 1 and 9 999.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14014 [Channel %1: ] Selected program %3 not available or will be edited

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Program name

Definitions: The selected parts program is not in the NCK memory or the access authorization for the program

selection is from a higher level than the current control status.

During creation, this program received the protection level of the NC control which was active at the

time.

In SW 5 or higher a program edited on HMI can no longer be started with NC Start.

The alarm will also be issued, if a file other than the specified definition file has been selected for the

GUD or macro definition.

Reaction: Alarm display.

Remedy: Reload the program in the NCK memory or check and correct the name of the directory (workpiece

overview) and the program (program overview) and reselect.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

14015 [Channel %1: ] Block %2 program %3 is not enabled

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Program name

Definitions: The execution right currently set in the control (e.g. key switch position 0) is inadequate to execute

part program %3.

Reaction: Correction block is reorganized.

Interface signals are set.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 92

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl