Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 310)

List of action numbers 06/2009

3-310

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

No. 104, SINGLEAX_STOPALARM_MASTER

No. 105, SINGLEAX_RESUME_MASTER

No. 106, SINGLEAX_RESET_MASTER

No. 107, SINGLEAX_DELDIS_MASTER

No. 108, SINGLEAX_PLCCTRL_ON_MASTER

No. 109, SINGLEAX_PLCCTRL_OFF_MASTER

Explanation Stopping of a single axis movement by an alarm

Cause The axis is not controlled by the PLC. (exception old reaction with oscillation axis).

Remedy -

Explanation Continuation of a single-axis movement (VDI signal).

Cause The axis has not been stopped previously. Not for all axis types at present.

Remedy -

Explanation Interruption of a single-axis movement (VDI signal).

Cause The axis is not controlled by the PLC. Not for all axis types at present.

Remedy -

Explanation Deletion of distance-to-go of a single-axis movement (VDI signal).

Cause The axis is not controlled by the PLC. Not for all axis types at present.

Remedy -

Explanation Power ON: Axis is now controlled by the PLC (VDI signal).

Cause The axis is not controlled by the PLC. Not for all axis types at present.

Remedy -

Explanation Deactivate: Axis is now controlled by the PLC (VDI signal).

Cause The axis is not controlled by the PLC. Not for all axis types at present.

Remedy -

1 2 ... 305 306 307 308 309 310 311 312 313 314 315 ... 339 340

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 310