Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 229)

Cycle alarms

06/2009 Overview of alarms

2-229

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61280 [Channel %1: ] Block %2: Mirroring in WO %4 missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If the program starts with a counterspindle movement, a work offset with mirroring will have to be

selected.

Alarm triggered by following cycle: F_SUB_SP

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select the mirroring for the work offset used.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61281 [Channel %1: ] Block %2: starting point of machining outside retraction

planes

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The starting point of machining is outside the retraction planes.

Alarm triggered by following cycle: F_SP_RP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Adjust the retraction planes.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61282 [Channel %1: ] Block %2: end point of machining outside retraction

planes

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The end point of machining is outside the retraction planes.

Alarm triggered by following cycle: F_SP_RP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Adjust the retraction planes.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61283 [Channel %1: ] Block %2: direct approach not possible, as tool change

required

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: After block search a position is to be reached by direct approach, but a tool change is required before.

Alarm triggered by following cycle: F_TFS.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: First execute a manual tool change, then restart the block search.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 229

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl