Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 208)

Overview of alarms 06/2009

Cycle alarms

2-208

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61157 [Channel %1: ] Block %2: Reference point wrongly programmed

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE899

Remedy: Check reference point in screen form, input only -X, centred or +X

61158 [Channel %1: ] Block %2: Machining plane wrongly programmed

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE899

Remedy: Check machining plane (G17, G18 or G19)

61159 [Channel %1: ] Block %2: Machining plane on cycle call differs from the

one in the position pattern

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE899

Remedy: Adjust the machining plane on cycle call to the machining plane in the position pattern.

61160 [Channel %1: ] Block %2: Residual material remains stationary, reduce

plane infeed

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE899

Remedy: Reduce plane infeed or slot width, or use milling cutter with larger diameter

61161 [Channel %1: ] Block %2: Centering diameter or tool parameter

(diameter, tip angle) are incorrect

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE81

Remedy: - Diameter of centering with tip angle of active tool not possible

- Entered workpiece diameter, tool diameter or tip angle of tool incorrect

- Diameter of tool only has to be entered if centering is to be on workpiece diameter.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61162 [Channel %1: ] Block %2: Tool parameter diameter or tip angle incorrect

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm is triggered by the following cycle: CYCLE81

Remedy: - The tool parameter diameter or tip angle must be greater than zero

- Tip angle must be less than 180°

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61175 [Channel %1: ] Block %2: angle of aperture _DF programmed too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The angle of aperture of the text in the engraving cycle is too small. This means that the text for

engraving does not fit in the specified angle.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter a larger angle of aperture.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 208

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl