Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 116)

Overview of alarms 06/2009

NCK alarms

2-116

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

14824 [Channel %1: ] Block %2 conflict with GWPS

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The functions of constant grinding wheel surface speed GWPS and constant cutting speed G96 S...

have been activated at the same time for a spindle.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14840 [Channel %1: ] Block %2 incorrect value range for constant cutting speed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The programmed cutting speed is not within the input range

Input range metric: 0.01 to 9 999.99 [m/min]

Input range inch: 0.1 to 99 999.99 [inch/min]

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program cutting speed under address S within the permissible range of values.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14900 [Channel %1: ] Block %2 center point and end point programmed

simultaneously

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: When programming a circle by means of the opening angle, the circle center point was programmed

together with the circle end point. This is too much information for the circle. Only one of the two points

is allowed.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Select the programming variant guaranteeing that the dimensions are definitely taken over from the

workpiece drawing (avoidance of calculation errors).

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14910 [Channel %1: ] Block %2 invalid angle of aperture for programmed circle

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: When programming a circle by means of the opening angle, a negative opening angle or an opening

angle greater than or equal to 360 degrees has been programmed.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program opening angle within the allowed range of values between 0.0001 and 359.9999 [degrees].

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14920 [Channel %1: ] Block %2 intermediate point of circle incorrect

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: When programming a circle by means of an intermediate point (CIP) all 3 points (initial, end and inter-

mediate points) are on a straight line and the intermediate point (programmed by means of interpola-

tion parameters I, J, K) is not located between the initial and end points.

If the circle is the component of a helix, the specified number of turns (keyword TURN=...) determines

further block processing:

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 116

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl