Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 232)

Overview of alarms 06/2009

Cycle alarms

2-232

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61306 [Channel %1: ] Block %2: Permissible measuring difference exceeded

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm triggered by following cycles: CYCLE971, CYCLE972, CYCLE974, CYCLE977, CYCLE978,

CYCLE979, CYCLE982, CYCLE994.

Remedy: -Check setpoint value

-Increase parameter _TDIF

61307 [Channel %1: ] Block %2: Incorrect measuring variant

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: The value of parameter _MVAR is impermissible.

61308 [Channel %1: ] Block %2: Check measuring path _FA

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A traversing path for measuring was generated whose size was specified by parameter _FA that

describes the maximum distance before and after the switching position (workpiece edge) and that

must have a value greater than 0.

Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: Check parameter _FA.

61309 [Channel %1: ] Block %2: Check probe type

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Probe type: 3D probe inactive.

This alarm is generated by all cycles except for CYCLE971, CYCLE972, CYCLE982.

Remedy: The probe has to be of the "3D probe" type in the tool management.

Tool type of the workpiece probe in the TO memory is impermissible.

For CYCLE971: no permissible tool probe type entered in _TP[x,8], or check

the permissible working plane G17...G19 for tool type "Wheel".

61310 [Channel %1: ] Block %2: Scale factor is active

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Scale factor = scaling is active.

Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: Switch off the active scale factor in the program. Measuring is not possible with an active scale factor.

61311 [Channel %1: ] Block %2: No D number active

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No tool offset for the measuring probe (for workpiece measurement) or no tool offset for the active tool

(for tool measurement) is selected.

Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: Select the tool's tool edge number D.

61312 [Channel %1: ] Block %2: Check measuring cycle number

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The alarm can be triggered by the following measuring cycles: all measuring cycles.

Remedy: Measuring cycle called is impermissible...

61313 [Channel %1: ] Block %2: Check probe number

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The probe has an impermissible value (_PRNUM).

The alarm can be triggered by the following measuring cycles: all measuring cycles.

Remedy: Correct _PRNUM or create data field _TP[] or _WP[] for additional tool or workpiece probe

1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 232

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl