Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 230)

Overview of alarms 06/2009

Cycle alarms

2-230

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61284 [Channel %1: ] Block %2: starting point cannot be approached without

collision. Pre-position tool manually

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The starting point cannot be approached without collisions.

Alarm triggered by following cycles: F_DRILL, F_DRILLC, F_DRILLD, F_DRM_DR, F_DRM_PE,

F_DRM_RE, F_DRM_SI, F_DRM_TA, F_GROOV, F_MIM_TR, F_PARTOF, F_SP_EF, F_TAP,

F_TR_CON, F_UCUT_T.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Preposition the tool manually.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61285 [Channel %1: ] Block %2: parking position is below return plane XRA.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The parking position is below retraction plane XRA.

Alarm triggered by following cycle: F_SP_RP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Move the parking position above retraction plane XRA.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61286 [Channel %1: ] Block %2: machining not possible, check tool angle.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Machining not possible with the specified tool.

Alarm triggered by following cycles: F_UCUT_T.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use a suitable tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61287 [Channel %1: ] Block %2: no master spindle active.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No master spindle active.

Alarm triggered by following cycle: F_TFS.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Activate the master spindle (machine data 20090).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61300 [Channel %1: ] Block %2: Probe defective

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 230

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl