Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 227)

Cycle alarms

06/2009 Overview of alarms

2-227

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61271 [Channel %1: ] Block %2: Chamfer width > tool radius

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Chamfer width larger than tool radius.

Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use a larger tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61272 [Channel %1: ] Block %2: Insertion depth too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Insertion depth on chamfering too small.

Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase the insertion depth.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61273 [Channel %1: ] Block %2: Insertion depth too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Insertion depth on chamfering too large.

Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Decrease the insertion depth.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61274 [Channel %1: ] Block %2: Invalid tool angle

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Invalid tool angle.

Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check tool angle.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61275 [Channel %1: ] Block %2: Target point violates software limit switch!

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Due to a swivel action, the end point is outside the software limit switches.

1 2 ... 222 223 224 225 226 227 228 229 230 231 232 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 227

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl