Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 235)

Cycle alarms

06/2009 Overview of alarms

2-235

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Check MD 20080 or MD 30300.

61330 [Channel %1: ] Block %2: Coordinate rotation active

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No measuring possible in the rotated coordinate system. Alarm is triggered: CYCLE972, CYCLE973,

CYCLE974, CYCLE994.

Remedy: Check the conditions for measuring.

61331 [Channel %1: ] Block %2: Angle too large, change measuring axis

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Parameter _STA is too large of the specified metering shaft. Alarm is triggered: CYCLE998.

Remedy: Select another metering axis.

61332 [Channel %1: ] Block %2: Modify tool tip position

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The tool tip is below the measuring probe surface (e.g. for a ring gauge or cube). Alarm is triggered:

CYCLE971, CYLCE972, CYCLE982, E_MT_CAL, E_MT_LEN, E_MT_RAD.

Remedy: Place the tool above the measuring probe surface.

61333 [Channel %1: ] Block %2: Check calibration facility number

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Parameter _CALNUM is too large. Alarm is triggered: CYCLE973.

Remedy: Reduce _CALNUM to a permissible value or increase maximum value _CVAL[2] in GUD6.

61334 [Channel %1: ] Block %2: Check safety area

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Parameter _SZA, _SZO too large or too small. Alarm is triggered: CYCLE977.

Remedy: Check parameter _SZA, _SZO.

61336 [Channel %1: ] Block %2: Geometry axes do not exist

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: No geometry axes configured. Alarm can be triggered by following measuring cycles: all measuring

cycles.

Remedy: Machine data in MD 20060 must be changed.

61337 [Channel %1: ] Block %2: Check measuring input

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61338 [Channel %1: ] Block %2: Positioning speed equal to zero

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: For some measuring versions, for example measuring spigots, in addition to the actual measuring

paths, intermediate paths are generated that are traversed with a specified feed. The values for the

feed are specified in parameters _SPEED[1] and _SPEED[2] in GUD6.

Alarm triggered by following measuring cycles: all measuring cycles.

1 2 ... 230 231 232 233 234 235 236 237 238 239 240 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 235

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl