Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 148)

Overview of alarms 06/2009

NCK alarms

2-148

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17181 [Channel %1: ] Block %2 T no.= %3, D no.= %4 not existing

Parameters: %1 = Channel number

%2 = Block number, label

%3 = T number

%4 = D number

Definitions: A programmed D number was not recognized by the NC. By default, the D number refers to the spec-

ified T number. If the flat D number function is active, T= 1 is output.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: If the program is incorrect, remedy the error with a correction block and continue the program.

If the data block is missing, download a data block for the specified T/D values onto the NCK (via HMI

with overstore) and continue the program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17183 [Channel %1: ] Block %2 H number already available in T no.= %3, D no.=

Parameters: %1 = Channel number

%2 = Block number, label

%3 = T number

%4 = D number

Definitions: Each H number (except for H=0) must be assigned in a TO unit only once. The indicated edge already

has the H number. If the H number shall be assigned more than once, MD10890

$MN_EXTERN_TOOLPROG_MODE, bit 3 must be set = 1.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: - Change program:

- Select different H number

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17188 [Channel %1: ] D number %2 defined in tool T no. %3 and %4

Parameters: %1 = Channel number

%2 = Offset number D

%3 = T number of first tool

%4 = T number of second tool

Definitions: The specified D number %2 in the TO unit of channel %1 is not unique. The specified T numbers %3

and %4 each have an offset with number %2. If tool management is active: The specified T numbers

belong to tool groups with different names.

Reaction: Interface signals are set.

Alarm display.

Remedy: 1. Ensure that the D numbers within the TO unit are unique.

2. If unique numbering is not necessary for subsequent operations, do not use the command.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

17190 [Channel %1: ] Block %2 illegal T number %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = T number

Definitions: In the displayed block, access is made to a tool that is not defined and therefore not available. The

tool has been named by its T number, its name or its name and duplo number.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 148

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl