Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 152)

Overview of alarms 06/2009

NCK alarms

2-152

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Definitions: In the displayed block, an axis is programmed for reference point approach (G74) that is involved in

the active transformation. Reference point approach is not performed with this axis!

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Remove G74 instruction, or the machine axes involved in transformation, from the part program block

or previously deselect the transformation with TRAFOOF.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17640 [Channel %1: ] Block %2 spindle operation for transformed axis %3 not

possible

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: The axis programmed for the spindle operation is involved in the current transformation as geometry

axis. This is not allowed.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: First switch off the transformation function.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17650 [Channel %1: ] Block %2 machine axis %3 not programmable

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: The machine axis cannot be used in an active transformation. You may be able to program the func-

tion in a different coordinate system. For example, it may be possible to specify the retraction position

in the basic coordinate system or the workpiece coordinate system. The axis identifier is used to select

the coordinate system.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Deactivate the transformation or use another coordinate system.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17800 [Channel %1: ] Block %2 illegally coded position programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The position number n specified with the keyword FP=n is not permissible. Two (2) absolute axis posi-

tions can be directly defined as fixed points by the axis-specific machine data MD30600

$MA_FIX_POINT_POS[n].

Or, if position numbers 3 and/or 4 are to be used, then machine data MD30610

$MA_NUM_FIX_POINT_POS must be set accordingly.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program keyword FP with machine fixed points 1 or 2.

Example:

Approach fixed point 2 with machine axes X1 and Z2.

N100 G75 FP=2 X1=0 Z2=0

Or modify MD30610 $MA_NUM_FIX_POINT_POS and, if necessary, MD30600

$MA_FIX_POINT_POS[].

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 152

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl