Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 255)

Cycle alarms

06/2009 Overview of alarms

2-255

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61613 [Channel %1: ] Block %2: Undercut position incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE94, CYCLE96.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check value in parameter _VARI.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61701 [Channel %1: ] Block %2: Error in finished part contour description

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Either none of parameters _NP1, _NP2 and _NP3 supplied or error in finished part contour program-

ming.

Alarm triggered by following cycle: CYCLE950

Remedy: - Check parameters _NP1, _NP2 and _NP3.

- Check finished-part contour programming.

61702 [Channel %1: ] Block %2: Error in blank contour description

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Either none of parameters _NP5, _NP6 and _NP7 supplied or error in blank contour programming.

The alarm is triggered by the following cycles: CYCLE950

Remedy: - Check parameters _NP5, _NP6 and _NP7.

- Check blank contour programming.

61703 [Channel %1: ] Block %2: Internal cycle error while deleting file

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61704 [Channel %1: ] Block %2: Internal cycle error while writing to file

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61705 [Channel %1: ] Block %2: Internal cycle error while reading to file

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61706 [Channel %1: ] Block %2: Internal cycle error while generating checksum

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61707 [Channel %1: ] Block %2: internal cycle error with ACTIVATE at HMI

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.

Remedy: --

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 255

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl