Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 204)

Overview of alarms 06/2009

Cycle alarms

2-204

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61126 [Channel %1: ] Block %2: Thread length too short

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE840.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Program lower spindle speed/raise reference plane.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61127 [Channel %1: ] Block %2: Wrong definition of tapping axis

transformation ratio (machine data)

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check machine data 31050 and 31060 in the appropriate gear stage of the drilling axis.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61128 [Channel %1: ] Block %2: Insertion angle = 0 for insertion with oscillation

or helix

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: SLOT1.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check parameter _STA2.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61129 [Channel %1: ] Block %2: perpendic. approach and retraction during

contour milling only allowed with G40

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61130 [Channel %1: ] Block %2: positions of parallel axes cannot be

compensated. No workpiece reference agreed.

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 204

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl