Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 198)

Overview of alarms 06/2009

Cycle alarms

2-198

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61025 [Channel %1: ] Block %2: Check tool carrier position

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm triggered by following cycles: .

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61026 [Channel %1: ] Block %2: Cycle cannot be executed with NC function %4.

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm triggered by following cycles: .

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61099 [Channel %1: ] Block %2: Internal cycle error (%4)

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: Alarm triggered by following cycles: .

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61101 [Channel %1: ] Block %2: Reference plane incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE71, CYCLE72, CYCLE81 to CYCLE90, CYCLE840,

SLOT1, SLOT2, POCKET1 to POCKET4, LONGHOLE.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: With the relative specification of the depth, either different values for the reference plane and the

retraction plane must be selected or an absolute value must be specified for the depth.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61102 [Channel %1: ] Block %2: No spindle direction programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE86, CYCLE87, CYCLE88, CYCLE840, POCKET3,

POCKET4.

Reaction: Interpreter stop

NC Start disable in this channel.

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 198

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl