Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 56)

Overview of alarms 06/2009

NCK alarms

2-56

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

10764 [Channel %1: ] Block %2 discontinuous path with active tool radius

compensation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: This alarm occurs when, with active tool radius compensation, the starting point used for calculating

the compensation is not identical to the end point of the preceding block. This situation can occur, for

example, when a geometry axis is traversed between two positions as a positioning axis or when, with

an active kinematic transformation (e.g. 5-axis transformation) the tool length compensation is altered.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10765 [Channel %1: ] Block %2 3D tool radius compensation not possible

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: This alarm occurs when an attempt is made to activate the 3D tool radius compensation even though

the option required for this is not fitted in the control.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: The option cannot be activated by altering machine data because the necessary code is not physically

available.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10776 [Channel %1: ] Block%2 axis %3 must be geometry axis if tool radius

compensation is active

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name

Definitions: This alarm occurs when an axis that is required for tool radius compensation is not a geometry axis.

With CUT2DF, the axis can be a positioning axis perpendicular to the machining plane; with all other

types of compensation (CUT2DF, CUT3DC, CUT3DF, CUT3DFF), all geometry axes must be oper-

ated as such.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

On selection of G41/42, the axes involved must be known as GEOAX in the channel. It is possible by

programming GEOAX() or G91 G0 X0 Y0 in the block prior to G41/42.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10777 [Channel %1: ] Block %2 tool radius compensation: too many blocks with

suppression of compensation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The maximum permissible number of blocks with active compensation suppression with tool radius

compensation is limited by MD20252 $MC_CUTCOM_MAXNUM_SUPPR_BLOCKS.

Reaction: Correction block is reorganized.

Local alarm reaction.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 56

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl