Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 28)

Overview of alarms 06/2009

NCK alarms

2-28

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Program Con-

tinuation:

Switch control OFF - ON.

4300 Declaration in MD %1 is not allowed for axis %2.

Parameters: %1 = String: MD identifier

%2 = Axis name, spindle number

Definitions: The axis cannot be operated as competing positioning axes,

for example because the axis is the slave axis within a closed gantry group or a gantry group to be

closed.

Reaction: Alarm display.

Remedy: Please inform the authorized personnel/service department. Reset MD30450

$MA_IS_CONCURRENT_POS_AX for the axis concerned.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

4310 Declaration in MD %1 index %2 is not allowed.

Parameters: %1 = String: MD identifier

%2 = Index: MD array index

Definitions: The machine data values must be written in the array in ascending order.

Reaction: Mode group not ready.

Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department. Correct the MD.

Program Con-

tinuation:

Clear alarm with the RESET key in all channels of this mode group. Restart part program.

4320 Axis %1 function %2 %3 and %4 not allowed

Parameters: %1 = String: Axis identifier

%2 = String: MD identifier

%3 = String: Bit

%4 = String: MD identifier

Definitions: The functions declared by the specified machine data cannot simultaneously be active for one axis.

Reaction: Mode group not ready.

Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Deactivate one of the functions.

Program Con-

tinuation:

Switch control OFF - ON.

4340 [Channel %1: ] Block %2 invalid transformation type in transformation

no. %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Transformation number

Definitions: An invalid, i.e. undefined, number was entered in one of the machine data TRAFO_TYPE_1 ...

TRAFO_TYPE_8. This alarm also occurs if a certain type of transformation is only impossible on the

type of control used (e.g. 5-axis transformation on a SINUMERIK 802D sl).

Reaction: Correction block is reorganized.802D sl

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Enter a valid transformation type.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl