Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 217)

Cycle alarms

06/2009 Overview of alarms

2-217

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a suitable tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61221 [Channel %1: ] Block %2: No tool active

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No tool active.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a suitable tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61222 [Channel %1: ] Block %2: Plane infeed greater than tool diameter

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The plane infeed must not be greater than the tool diameter.

Alarm triggered by following cycles: CYCLE79, , E_MI_PL, E_PO_CIR, E_PO_REC, F_PO_CIR,

F_PO_REC.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Reduce plane infeed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61223 [Channel %1: ] Block %2: Approach path too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The approach path must not be less than zero.

Alarm triggered by following cycles: E_MI_CON, F_MI_CON.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter a greater value for the approach path.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61224 [Channel %1: ] Block %2: Retract path too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The retract path must not be less than zero.

Alarm triggered by following cycles: E_MI_CON, F_MI_CON.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter a greater value for the retract path.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 217

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl