Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 231)

Cycle alarms

06/2009 Overview of alarms

2-231

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61301 [Channel %1: ] Block %2: Probe not switching

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The measuring distance was completely traversed but no switching signal was generated at the mea-

suring input.

Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: -Check measuring input.

-Check measuring distance.

-Probe defective.

61302 [Channel %1: ] Block %2: Probe - collision

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The measuring probe collided with an obstacle when being positioned.

Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: ? Check spigot diameter (may be too small)

? Check measuring distance (may be to long)

61303 [Channel %1: ] Block %2: Safety margin exceeded

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The measuring result differs greatly from the specified value.

Alarm can be triggered by following measuring cycles: all measuring cycles.

Remedy: -Check setpoint value.

-Increase parameter _TSA.

61304 [Channel %1: ] Block %2: Allowance

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61305 [Channel %1: ] Block %2: Dimension too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 231

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl