Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 194)

Overview of alarms 06/2009

Cycle alarms

2-194

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61004 [Channel %1: ] Block %2: Incorrect configuration of geometry axes

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The geometry-axes sequence is wrong. CYCLE328

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61005 [Channel %1: ] Block %2: 3rd geometry axis not available

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: With an application on the lathe with no Y-axis in the G18 plane. Alarm triggered by following cycle:

CYCLE86.

Remedy: Check parameter on cycle call.

61006 [Channel %1: ] Block %2: Tool radius too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The tool radius is too large for machining. Alarm triggered by following cycles: CYCLE930,

CYCLE951, E_CP_CE, E_CP_CO, E_CP_DR, E_PO_CIR, E_PO_REC, F_CP_CE, F_CP_CO,

F_CP_DR, F_PO_CIR, F_PO_REC.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a smaller tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61007 [Channel %1: ] Block %2: Tool radius too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The tool radius is too small for machining. Alarm triggered by following cycles: CYCLE92, E_CP_CO,

E_SL_CIR, F_CP_CO, F_PARTOF, F_SL_CIR.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a larger tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61008 [Channel %1: ] Block %2: No tool active

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles:

Remedy: Select a tool.

61009 [Channel %1: ] Block %2: Active tool number = 0

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No tool (T) has been programmed before the cycle call. Alarm triggered by following cycles:

CYCLE71, CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 194

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl