Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 115)

NCK alarms

06/2009 Overview of alarms

2-115

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Program the positioning velocity within the limits given above.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14811 [Channel %1: ] Block %2 incorrect value range for acceleration of

axis/spindle %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis, spindle

Definitions: A value outside of the permissible input range of the programmed acceleration has been used. Values

of between 1 and 200 % are possible.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Adjust the value range in accordance with the Programming Guide. Values of 1 ... 200% are allowed.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14812 [Channel %1: ] Block %2 SOFTA not available for axis %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis

Definitions: SOFT is to be set as type of motion control for an axis. This is not possible because a bent acceleration

characteristic has been selected for this axis via machine data.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program or machine data.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14815 [Channel %1: ] Block %2 negative thread pitch change programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A negative thread pitch change has been programmed.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Correct the value assignment. The programmed F value should be greater than zero. Zero is allowed

but has no effect.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14820 [Channel %1: ] Block %2 negative value for maximum spindle speed

programmed with constant cutting speed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: For the function "Constant cutting speed G96" a maximum spindle speed can be programmed with

the keyword LIMS=.... The values are in the range 0.1 - 999 999.9 [rev/min].

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program the maximum spindle speed for the constant cutting speed within the limits given above. The

keyword LIMS is modal and can either be placed in front of or within the block that selects the constant

cutting speed.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 115

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl