Siemens SINUMERIK 802D sl Manuel de l'opérateur télécharger pdf (Page 101)

NCK alarms

06/2009 Overview of alarms

2-101

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

14170 [Channel %1: ] Block %2 illegal interpolation type with tool length

compensation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If tool compensation (G43/G44) is activated in language mode ISO_M, the linear type of interpolation

must be active.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14180 [Channel %1: ] Block %2 H number %3 is not defined

Parameters: %1 = Channel number

%2 = Block number, label

%3 = H number of ISO mode

Definitions: The specified H number is not assigned to a tool (ISO_M).

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14185 [Channel %1: ] Block %2 D number %3 is not defined

Parameters: %1 = Channel number

%2 = Block number, label

%3 = D number of ISO mode

Definitions: The specified D number is not assigned to a tool (language mode ISO_M).

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14197 [Channel %1: ] Block %2 D number and H number programmed

simultaneously

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A D word and H word have been programmed simultaneously.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14198 [Channel %1: ] Block %2 illegal change of tool direction with tool offset

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 339 340

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Manuel de l'opérateur Page 101

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl