Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 51)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-51

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Program Con-

tinuation:

Switch control OFF - ON.

8023 Option 'Activation of more than %1 KB PLC user memory' not set

Parameters: %1 = Memory size

Definitions: The option for the memory configuration does not correspond to the PLC user memory used.

Reaction: NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department.

- Purchase option

- Use less PLC user memory

Program Con-

tinuation:

Switch control OFF - ON.

8030 Channel %1 block %2 option 'interpolation of more than 4 axes' not set

Parameters: %1 = channel number

%2 = block number, label

Definitions: The option for the number of interpolating axes does not correspond to the number of axes pro-

grammed in the interpolation group.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Only so many axes can be programmed in the part program as correspond to the configuration of the

control.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

8032 Option 'activation of more than %1 link axes' not set

Parameters: %1 = Number of axes

Definitions: The option for the number of link axes does not match the number of axes programmed in MD

$MN_AXCONF_LOGIC_MACHAX_TAB.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: - Buy option

- Configure fewer link axes

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

8034 Option 'activation of axis containers' not set

Definitions: The option for activating the axis container function in MD $MN_AXCONF_LOGIC_MACHAX_TAB is

not enabled.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: - Buy option

- Do not configure any containers

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 391 392

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Spécifications Page 51

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl