Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 304)

Overview of alarms 06/2007

Cycle alarms

2-304

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61282 Channel %1 block %2: end point of machining outside retraction planes

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The end point of machining is outside the retraction planes.

Alarm triggered by following cycle: F_SP_RP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Adjust the retraction planes.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61283 Channel %1 block %2: direct approach not possible, as tool change

required

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: After block search a position is to be reached by direct approach, but a tool change is required before.

Alarm triggered by following cycle: F_TFS.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: First execute a manual tool change, then restart the block search.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61284 Channel %1 block %2: starting point cannot be approached without

collision. Pre-position tool manually

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The starting point cannot be approached without collisions.

Alarm triggered by following cycles: F_DRILL, F_DRILLC, F_DRILLD, F_DRM_DR, F_DRM_PE,

F_DRM_RE, F_DRM_SI, F_DRM_TA, F_GROOV, F_MIM_TR, F_PARTOF, F_SP_EF, F_TAP,

F_TR_CON, F_UCUT_T.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Preposition the tool manually.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61285 Channel %1 block %2: parking position is below return plane XRA.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The parking position is below retraction plane XRA.

Alarm triggered by following cycle: F_SP_RP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Move the parking position above retraction plane XRA.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 299 300 301 302 303 304 305 306 307 308 309 ... 391 392

Siemens SINUMERIK 802D sl Spécifications Page 304

Commentaires sur ces manuels

Siemens SINUMERIK 802D sl Spécifications Page 304

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl