Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 277)

Cycle alarms

06/2007 Overview of alarms

2-277

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61109 Channel %1 Block %2: Parameter _CDIR incorrectly defined

Parameters:

Definitions: Source (cycle):

POCKET3

POCKET4

Remedy: The cutting direction _CDIR parameter has been set to the wrong value and needs to be altered.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61110 Channel %1 Block %2: Finishing allowance at bottom > depth infeed

Parameters:

Definitions: Source (cycle):

POCKET3

POCKET4

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The finishing allowance at the base has been specified to be larger than the maximum depth infeed;

either reduce the finishing allowance or increase the depth infeed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61111 Channel %1 Block %2: Infeed width > Tool diameter

Parameters:

Definitions: Source (cycle):

CYCLE71

POCKET3

POCKET4

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The programmed infeed width is greater than the diameter of the active tool. It must be reduced.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61112 Channel %1 Block %2: Tool radius negative

Parameters:

Definitions: Source (cycle):

CYCLE72

Remedy: The radius of the active tool is negative. This is not permitted.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61113 Channel %1 Block %2: Parameter _CRAD too large for corner radius

Parameters:

Definitions: Source (cycle):

POCKET3

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The parameter for the corner radius _CRAD has been set too large. It must be decreased.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 272 273 274 275 276 277 278 279 280 281 282 ... 391 392

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Spécifications Page 277

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl