Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 208)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-208

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

17610 Channel %1 block %2 axis %3 involved in the transformation, action

cannot be carried out

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

Definitions: The axis addressed by vocabulary word POS or POSA is involved in the active transformation. There-

fore, it cannot traverse as a positioning axis.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Remove POS or POSA instruction from the part program block or deselect transformation with TRA-

FOOF beforehand.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17620 Channel %1 block %2 approaching fixed point for transformed axis %3

not possible

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

Definitions: In the displayed block, an axis is programmed for the fixed point approach (G75) that is involved in the

active transformation. Fixed point approach is not performed with this axis!

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Remove G75 instruction from the part program block or deselect transformation with TRAFOOF

beforehand.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17630 Channel %1 block %2 referencing for transformed axis %3 not possible

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

Definitions: In the displayed block, an axis is programmed for reference point approach (G74) that is involved in

the active transformation. Reference point approach is not performed with this axis!

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Remove G74 instruction, or the machine axes involved in transformation, from the part program block

or deselect the transformation with TRAFOOF beforehand.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17640 Channel %1 block %2 spindle operation for transformed axis %3 not

possible

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

Definitions: The axis programmed for the spindle operation is involved in the current transformation as geometry

axis. This is illegal.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: First switch off the transformation function.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 391 392

Siemens SINUMERIK 802D sl Spécifications Page 208

Commentaires sur ces manuels

Siemens SINUMERIK 802D sl Spécifications Page 208

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl