Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 271)

Cycle alarms

06/2007 Overview of alarms

2-271

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61009 Channel %1 Block %2: Active tool number = 0

Parameters:

Definitions: Source (cycle):

CYCLE71

CYCLE72

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: No tool (T) has been programmed before the cycle call.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61010 Channel %1 Block %2: Finishing allowance too large

Parameters:

Definitions: Source (cycle):

CYCLE71

CYCLE72

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: An active scaling factor is active which is not permissible for this cycle.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61011 Channel %1 Block %2: Scaling not permissible

Parameters:

Definitions: Source (cycle):

CYCLE72

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The finishing allowance at the base is larger than the overall depth, it must be reduced.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61012 Channel %1 Block %2: Different scaling in planes

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE76, CYCLE77.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 266 267 268 269 270 271 272 273 274 275 276 ... 391 392

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Spécifications Page 271

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl