Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 160)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-160

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

15700 Channel %1 block %2 illegal cycle alarm number %3

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A SETAL command with a cycle alarm number smaller than

60,000 or larger than 67,999 has been programmed.

Alarm Reactions of Siemens standard cycles:

No. 61 000 - 61 999: Interpreter stop; delete with reset

No. 62 000 - 62 999: Compensation block; delete with NC Start

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Program alarm number in the SETAL instruction in the correct range.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

15800 Channel %1 block %2 wrong starting conditions for

CONTPRON/CONTDCON

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The starting conditions are faulty for the contour preparation (CYCLE 95):

G40 (deselection of the tool radius compensation) is not active

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Change part program: Deselect tool radius compensation with G40.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

15810 Channel %1 block %2 wrong array dimension for

CONTPRON/CONTDCON

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The column number for a contour table has a fixed size. The current value is contained in the current

Technology Programmer's Guide.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Correct the array definition for the contour table.

The number of rows can be defined freely and corresponds to the number of contour elements (circles,

straight lines). The number of columns is fixed (see the Cycle Programming Guide).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

15900 Channel %1 block %2 touch probe not allowed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A non-existent touch probe for measuring with deletion of remaining distance has been selected in the

part program.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Change part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 391 392

Siemens SINUMERIK 802D sl Spécifications Page 160

Commentaires sur ces manuels

Siemens SINUMERIK 802D sl Spécifications Page 160

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl