Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 158)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-158

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

15350 Channel %1 block %2 search target not found

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified program has been searched to the end of the program without the selected search tar-

get having been found.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check the part program, change the block search (typing error in the part program) and restart the

search.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

15360 Channel %1 illegal target of block search (syntax error)

Parameters: %1 = channel number

Definitions: The specified search target (block number, label or string) is not allowed in block search.

Reaction: Alarm display.

Remedy: Correct target of block search.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

15370 Channel %1 target of block search not found

Parameters: %1 = channel number

Definitions: In a block search, an impermissible search target has been specified (e.g. negative block number).

Reaction: Alarm display.

Remedy: Check the specified block number, label or character string. Repeat entry with correct search target.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

15380 Channel %1 block %2 illegal incremental programming in axis %3

Parameters: %1 = Channel number.

%2 = Block number, label.

%3 = Axis.

Definitions: A transformation change occurred after "search at block end".

The position accumulated during the search cannot be traversed incrementally.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Find search destination in which the axes are programmed using an absolute reference.

Deactivate adding of the accumulated search position with SD 42444 TARGET_BLOCK_INCR_ =

FALSE.

Use search run with calculation "at contour".

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

15400 Channel %1 block %2 selected initial init file does not exist

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The operator has selected an INI block for a read, write or execution function which:

1.Does not exist in the NC range or

2.Does not have the protection level required to perform the function

Reaction: Alarm display.

Remedy: Please inform the authorized personnel/service department.

Check whether the selected INI block is contained in the file system of the NC. The present protection

level must be selected to be at least equal to (or greater than) the protection level that has been

defined for the read, write or execution function at the time of creating the file.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 391 392

Siemens SINUMERIK 802D sl Spécifications Page 158

Commentaires sur ces manuels

Siemens SINUMERIK 802D sl Spécifications Page 158

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl