Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 292)

Overview of alarms 06/2007

Cycle alarms

2-292

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

Definitions: Only manual tools may be loaded into a swivel head in which only manual tools can be loaded.

The alarm is triggered by the following cycles: E_TD, E_TFS, F_TFS

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Load a manual tool into the swivel head or set the parameter "Tool change" in the start-up screen form

"Rotary axes" to "Automatic".

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61233 Channel %1 block %2: Thread angle wrongly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The thread angles were specified too large or too small.

Alarm triggered by following cycles: E_TR_CON, F_TR_CON

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check thread geometry.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61234 Channel %1 block %2: ShopMill subroutine %4 cannot be executed, as

not tested by ShopMill

Parameters: %1 = Channel number

%2 = Block number, label

%4 = Subroutine name

Definitions: Before a ShopMill subroutine can be used, it has to be tested by ShopMill.

Alarm triggered by following cycle: E_HEAD.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The subroutine has to be simulated first in ShopMill or loaded into the ShopMill operating mode

"Machine auto".

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61235 Channel %1 block %2: ShopTurn program %4 cannot be executed as not

tested by ShopTurn.

Parameters: %1 = Channel number

%2 = Block number, label

%4 = Program name

Definitions: Before a ShopTurn program can be executed, it has to be tested by ShopTurn.

Alarm triggered by following cycle: F_HEAD

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Simulate the subroutine first in ShopTurn or load it into the ShopTurn operating mode "Machine auto".

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61236 Channel %1 block %2: ShopTurn subroutine %4 cannot be executed as

not tested by ShopTurn.

Parameters: %1 = Channel number

%2 = Block number, label

%4 = Subroutine name

1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 391 392

Siemens SINUMERIK 802D sl Spécifications Page 292

Commentaires sur ces manuels

Siemens SINUMERIK 802D sl Spécifications Page 292

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl