Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 155)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-155

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

15165 Channel %1 block %2 error when translating or interpreting Asup %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = String

Definitions: At part program start and at start of an ASUB under Reset condition, the relevant data of all the ASUBs

that can be activated at that time are preprocessed:

- PLC ASUBs

- With $MC_PROG_EVENT_MASK configured event-controlled program calls

- ASUB after block search ($MN_SEARCH_RUN_MODE bit 1=1)

- Editable system ASUB ($MN_ASUP_EDITABLE)

If an error occurs (converter or interpreter), alarm 15165 will be output first and then a converter or

interpreter alarm that describes more details of the error. Alarm 15165 will cause an interpreter stop.

A compensation block will not be possible.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

15170 Channel %1 block %2 program %3 could not be compiled

Parameters: %1 = Channel number

%2 = Block number, label

%3 = String

Definitions: An error has occurred in compile mode. The (compiler) error message refers to the program specified

here.

Reaction: Alarm display.

Remedy: Correct part program.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

15175 Channel %1 block %2 program %3. Interfaces could not be built

Parameters: %1 = Channel number

%2 = Block number, label

%3 = String

Definitions: An error has occurred in interface generation mode. The (compiler) error message refers to the pro-

gram specified here.

Reaction: Alarm display.

Remedy: Correct part program.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

15180 Channel %1 block %2: Error on editing program %3 as INI/DEF file.

Parameters: %1 = Channel number

%2 = Block number, label

%3 = String

Definitions: An error occurred while reading the INI file. The error message refers to the program specified here.

Reaction: Alarm display.

Remedy: Correct part program.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

15185 Channel %1 %2 errors in INI file

Parameters: %1 = Channel number

%2 = Number of detected errors

Definitions: Errors detected while processing an INI file.

Reaction: NC Start disable in this channel.

Interface signals are set.

Alarm display.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 391 392

Siemens SINUMERIK 802D sl Spécifications Page 155

Commentaires sur ces manuels

Siemens SINUMERIK 802D sl Spécifications Page 155

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl