Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 295)

Cycle alarms

06/2007 Overview of alarms

2-295

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61244 Channel %1 block %2: Pitch change causing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified lead change causes a reversal of the thread direction.

Alarm triggered by following cycle: CYCLE99

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check lead change and thread geometry.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61245 Channel %1 block %2: Machining plane does not match modal

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Machining plane does not match modal one.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check the machining plane.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61246 Channel %1 block %2: Safety distance too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The safety clearance is too small for machining.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase safety clearance.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61247 Channel %1 block %2: Blank radius too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The blank radius is too small for machining.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase blank radius.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61248 Channel %1 block %2: Infeed too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The infeed is too small for machining.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

1 2 ... 290 291 292 293 294 295 296 297 298 299 300 ... 391 392

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Spécifications Page 295

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl