Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 248)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-248

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Definitions: It is impermissible to start a spindle as long as it is used by a transformation. Reason: spindle usage

in a transformation requires axis operation which must not be exited.

This alarm may have the following reasons:

- Error code 1 : M3, M4 or M5 per synchronized action;

- Error code 2 : M41 through M45 per synchronized action;

- Error code 3 : SPOS, M19 per synchronized action;

- Error code 11 : DBB30 spindle stop;

- Error code 12 : DBB30 spindle start clockwise rotation;

- Error code 13 : DBB30 spindle start counterclockwise rotation;

- Error code 14 : DBB30 spindle positioning.

Reaction: NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Resolve the conflict, for example by deactivating transformation prior to spindle start.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

22321 Channel %1 axis %2 PRESET not allowed during traverse motion

Parameters: %1 = channel number

%2 = block number, label

Definitions: A preset command was given from MMC or PLC while an axis was traveling in JOG mode.

Reaction: Interface signals are set.

Alarm display.

Remedy: Wait until the axis is stationary.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

22322 Channel %1 axis %2 PRESET: illegal value

Parameters: %1 = channel number

%2 = axis name, spindle number

Definitions: The entered Preset value is too large (number format overflow).

Reaction: NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Use more realistic (smaller) Preset values.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

22400 Channel %1 option 'contour handwheel' not set

Parameters: %1 = Channel number

Definitions: The function 'contour handwheel' was activated without the neccesary option.

If the alarm occurs

- on selection of the contour handwheel via the PLC, then the contour handwheel has to be deselected

in order to continue with the program

- on account of programming FD=0, then the program can be corrected and continued with the com-

pensation block and NCSTART.

Reaction: Alarm display.

Remedy: Please inform the authorized personnel/service department.

- Set option

- Cancel the activation of the function 'contour handwheel'

- Modify part program.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 391 392

Siemens SINUMERIK 802D sl Spécifications Page 248

Commentaires sur ces manuels

Siemens SINUMERIK 802D sl Spécifications Page 248

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl