Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 175)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-175

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

16748 Channel %1 block %2 spindle %3 gear stage %4 expected

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Spindle number

%4 = Gear stage

Definitions: G331 activates the second gear stage data block for tapping.

The programmed speed (S) of the master spindle lies outside the speed range of the active gear stage

in the current traversing block.

The gear stage cannot be changed in the traversing block. The gear stage appropriate for the speed

must be loaded prior to the traversing block.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Procedure for automatically engaging the suitable gear stage prior to thread cutting:

* Program the spindle speed (S) in a G331 block without axis motions and prior to thread cutting, e.g.

G331 S1000.

* Activate M40 for the spindle.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16750 Channel %1 block %2 axis %3 SPCON not programmed

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: For the programmed function (rotary axis, positioning axis), the spindle must be in position control

mode.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program position control of the spindle with SPCON in the previous

block.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16751 Channel %1 block %2 spindle/axis %3 SPCOF not executable

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

Definitions: For the programmed function, the spindle must be in the open-loop control mode.

In the positioning or axis mode, the position control must not be

deselected.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Put the spindle into open-loop control mode in the preceding block.

This can be done with M3, M4 or M5 for the relevant spindle.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16755 Channel %1 block %2 no stop required

Parameters: %1 = channel number

%2 = block number, label

Definitions: No Stop is needed for the programmed function. A Stop is necessary after SPOSA or after M5 if the

next block is to be applied only after the spindle has come to a stop.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Do not write instruction.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 391 392

Siemens SINUMERIK 802D sl Spécifications Page 175

Commentaires sur ces manuels

Siemens SINUMERIK 802D sl Spécifications Page 175

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl