Siemens SINUMERIK 802D sl Spécifications télécharger pdf (Page 296)

Overview of alarms 06/2007

Cycle alarms

2-296

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

Remedy: Increase infeed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61249 Channel %1 block %2: Number of edges too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The number of edges is too small.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase number of edges.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61250 Channel %1 block %2: Width across flats/edge length too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The width across flats/edge length is too small.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase key width/edge length.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61251 Channel %1 block %2: Width across flats/edge length too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The width across flats/edge length is too large.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Decrease key width/edge length.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61252 Channel %1 block %2: Chamfer/radius too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Chamfer/radius is too large.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Decrease chamfer/radius.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 391 392

Commentaires sur ces manuels

Pas de commentaire

Siemens SINUMERIK 802D sl Spécifications Page 296

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Siemens SINUMERIK 802D sl