Siemens SINAMICS G120 Instructions d'exploitation télécharger pdf (Page 70)

Commissioning

4.4 Commissioning with the BOP-2

Inverter with CU240B-2 and CU240E-2 Control Units

68 Operating Instructions, 01/2011, FW 4.4, A5E02299792B AB

4.4.3 Freely selecting and changing parameters

Use BOP-2 to change your inverter settings, by selecting the appropriate parameter number

and changing the parameter value. Parameter values can be changed in the "PARAMS"

menu and the "SETUP" menu.

OKESC

ESC

>2 sec

Select the parameter number Changing a parameter value

If the parameter number flashes in the display,

you have two options for changing the number:

If the parameter value flashes in the display, you

have two options of changing the value:

1. option: 2. option: 1. option: 2. option:

Increase or decrease

the parameter number

using the arrow keys

until the number you

want is displayed.

Press and hold the OK

key for more than two

seconds and change

the required parameter

number digit by digit.

Increase or decrease

the parameter value

using the arrow keys

until the value you want

is displayed.

Press and hold the OK

key for more than two

seconds and enter the

required value digit by

digit.

Confirm the parameter number using the OK key. Confirm the parameter value using the OK key.

The inverter immediately saves all changes which you made using the BOP-2 so that they

are protected against power failure.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 303 304

Pas de commentaire

Siemens SINAMICS G120 Instructions d'exploitation Page 70