Siemens DTU3005-B Manuel de l'opérateur télécharger pdf (Page 59)

8 Setting Options

Siemens Energy & Automation, Inc. 55

2. To select the printer port, or to direct the printouts

to a file, use the Left and Right Arrow keys to

move the highlight between File, LPT1, and LPT2.

With the desired selection port highlighted, press

the spacebar to select it. The dot at the cursor

indicates which choice is selected.

a. If you have selected File, use the Tab key to

move the highlight to the File Name field.

Enter a name for the file of up to eight letters

and numbers. This file will be saved to the

DTU3005 Editor software directory when you

select Print from the Project menu.

b. Next, enter the number of lines per page your

printer prints in the Lines/Page field. You may

want to print out a page to determine this

value.

3. Select Save to confirm your selections, then select

Ok to exit the screen. Select Revert to return to the

previously saved settings.

8.4 Loading and Saving Options

The Option settings are stored in file Editor.cfg on

the PC hard drive. When the Editor software is first

installed and operated, the Editor.cfg file contains

the default Option settings. If you make any changes

using the Options menu, the Editor software gives you

three choices for saving changes:

• If you want to keep these changes, you should

Save Options to disk. This action will save your

changes to the Editor.cfg file on the hard drive,

which makes these settings the new options.

• If you want to change Options only temporarily,

such as during a particular session you are run-

ning, then, you can make changes as desired but

not save the Options to disk.

• If you start changing Options for either permanent

or temporary use, then you change your mind and

want to restore the previous settings, you can

Load Options from Disk to load the previously

saved Options from the Editor.cfg file on the

hard drive.

In addition, the Default Options resets the Option set-

tings to the original default settings, which are the

options that were in effect when the program was first

installed and operated.

Example Procedure

1. To load previously saved options settings, select

Load Options from Disk from the Options menu.

The following screen appears:

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 140 141

Commentaires sur ces manuels

Pas de commentaire

Siemens DTU3005-B Manuel de l'opérateur Page 59

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Siemens DTU3005-B